- Strain-relieving Core
- The center core should be filled with a high-quality, high tensile strength core to protect the twisted conductors from falling into the center.
- Conductor Structure
- The copper stranding in Chainflex ® is chosen in accordance with tested and proven designs. Igus’ test results indicate that a medium to fine strand diameter is preferable. Most typical flexing cable designs will employ an extra-fine conductor strand, and have a tendency to kink when subjected to high-duty cycles. As a result of long-term testing, igus ® uses a combination of single-wire diameter, pitch length and pitch direction to achieve the best flex life performance in even the most emanding applications.
- Core Insulation
Insulation materials must be adhesion-resistant to one another within the cable.
The insulation must also support the stranded individual wires of the conductor.
Only the highest-quality, high-pressure-extruded PVC or TPE materials should
be used.
- Cable Core
Individual conductors are bundled in groups. These bundles are cabled together
in a single layer around the center strain relief. This design enables the pulling
and compressing forces of the bending motion to balance and cancels torsional
forces. Special attention is given to pitch length and pitch direction. Cables that
are not bundled are not suitable for long-travel applications.
- Inner Jacket
A gusset-filling extruded inner jacket should be used instead of inexpensive
fleece wrap or filler to ensure that the structure is efficiently guided in
longitudinal direction. The inner jacket will also maintain the integrity of the
cable core and provide a continuous base for the shield.
- Shield Design
A high-quality braided shield protects cables from external interference and
shields any interference before it is transmitted to the outside environment. An
optimized braid angle prevents the shield strands from breaking over the linear
axis and increases torsional stability. The shield has an optical coverage of
approximately 90%, providing maximum shield effectiveness.
- Outer Jacket
The outer jacket material must be UV-resistant, abrasion-resistant and resistant
to oils and chemicals, as well as cost-effective. However, it must not adhere to
anything and be flexible while providing support. It should also be extruded
under pressure (gusset-filled).