MTW釋疑
出自TSK WIKI
於 2015年4月11日 (六) 04:56 由
Root
(留言 | 貢獻) 所做的修訂
跳至導覽
跳至搜尋
網路訊息
NFPA 2007 VS NFPA 2012
- NFPA 79 Standards for AlphaWire
- Update_NFPA_2012_RR_en.pdf for igus
- NFPA 79 Standard Update: When to Use AWM Cables
- Safety standard gives appliance wire a new lease on life
- NFPA whitepaper 2012 for Lapp
- NFPA for LÜTZE
- [http://www.kuramo.co.jp/catalog/fa/data_fa_13.pdf
- NFPA 79 for AWM Cables in 2011
- NFPA 2007
- 12.2.7 Special Cables and Conductors.
- 12.2.7.1 Other listed conductors and listed cables shall be permitted.
- 12.2.7.2 Special conductors such as RG -/U transmission cable shall be permitted where necessary for the proper functioning of the equipment.
- 12.2.7.3* Appliance Wiring Material. Single conductor or multi-conductor Type AWM shall not be permitted.Exception: When part of a listed assembly suitable for the intended application, Type AWM shall be permissible.
- NFPA 2012
- 12.9 Special Cables and Conductors.
- 12.9.1 Other listed cables and conductors shall be permitted were identified as suitable for the intended use. 12.9.2 Appliance wiring material (AWM) shall be permitted as follows:
- Where part of an assembly that has been identified for the intended use
- Where the AWM has been identified for use with approved manufacturer’s instructions
- Where its construction meets all applicable requirements of Section 12.2 through Section 12.6 with modifications as follows:
- Stranded conductors with wire sizes smaller then those listed in 12.2.2 shall have a minimum of seven strands.
- Conductor insulation and cable jacket materials not specified in 12.3.1 shall have flame-resistant properties in compliance with applicable standards for intended use such as FT2 (horizontal wire) flame test or VW-1 (vertical wire) flame test in accordance with ANSI/UL 1581
- Minimum insulation thickness for single conductor AWM shall be specified in 12.3.2. Minimum insulation thickness for conductors that are part of a multi-conductor jacketed AWM cable shall be as specified by the AWM style number and by the marked voltage rating of the cable.
- AWM shall be marked in accordance with 12.4.1, 12.4.3, and 12.4.4. The legend shall include manufacturer's name or trademark, AWM style number, voltage rating (unless marking is prohibited by 12.4.2), wire gauge(s), temperature rating, and flame resistance. Additional markings for properties such as oils, water, UV, and chemical resistance identifiers shall be permitted where in compliance with applicable standards for intended use. Where markings alone are insufficient to identify for the intended application, suitable information shall be included with the machine technical documentation