「HYTREL製程改善」:修訂間差異

出自TSK WIKI
跳至導覽 跳至搜尋
Root​(留言 | 貢獻)
Root​(留言 | 貢獻)
第24行: 第24行:
==杜邦技術資料==
==杜邦技術資料==
*(L/D) ratio ideally 24:1
*(L/D) ratio ideally 24:1
* The optimum draw-down ratio (D.D.R.) is in the range of 5–20:1
* The optimum draw-down ratio (D.D.R.) is in the range of <span style="color:red">5–20:1</span>
*The extruder die should be between 2 and 3 times the required tube outside diameter
*The extruder die should be between 2 and 3 times the required tube outside diameter
*Vacuum of 0.10 to 0.30 bar has been used successfully to maintain  
*Vacuum of 0.10 to 0.30 bar has been used successfully to maintain  

於 2016年12月29日 (四) 16:25 的修訂

20161229

  • 溫度
    • 機頭260 -> 270
    • 洩料250 -> 260
    • 一段220 -> 230
    • 二段230 -> 240
    • 三段240 -> 250
  • 眼模
    • 內眼模2.7mm ->
    • 外眼模0.6/1.5mm ->
  • 間格 1 ->
  • 連動 -> 單動
  • 螺旋轉速rpm 21.7 -> 46.8
  • 引取轉速rpm 476 -> 551
  • 線速120 -> 145
  • 外徑測定器0.73 -> 0.73
  • 導体預熱 off -> 微溫40A/5.5V
  • 真空吸引 -> 0.45
  • DDR
    • (2.7^2-1.5^2)/(0.7^2-0.4^2)=15.27 ->
    • (2.9^2-1.5^2)/(0.7^2-0.4^2)=18.67
    • PDFXEdit_2016-12-29_16-11-48.png
    • PDFXEdit_2016-12-29_16-19-35.png

杜邦技術資料

  • (L/D) ratio ideally 24:1
  • The optimum draw-down ratio (D.D.R.) is in the range of 5–20:1
  • The extruder die should be between 2 and 3 times the required tube outside diameter
  • Vacuum of 0.10 to 0.30 bar has been used successfully to maintain
  • PDFXEdit_2016-12-29_16-14-03.png
  • PDFXEdit_2016-12-29_16-13-16.png
  • PDFXEdit_2016-12-29_16-13-34.png